I am trying to run Blinky on stm32 bluepill but I am getting error message....."Could not verify ST device! Please verify that the latest version of GDB-server is used for the connection"
I have also edited the stm32f1x.cfg file but the issue is same.
Debug Probe is ST-LINK(OpenOCD).
Related
I've got a new STM32L496G board I'm trying to program but running into an "st-link no target connected" issue. I've tried reinstalling the drivers multiple times but this hasn't resolved the issue. I'm running dual booted off a Mac and have to use a USB converter to connect the device, so I was wondering if using that converter could be causing the device to not be recognized. I'd appreciate any insight, I'm completely new to working with the board
I just try to install my code to card and i keep getting this error
Target no device found
Error in initializing ST-LINK device.
Reason: No device found on target.
I just randomly keep randomly keep reverting firmware and updating from cubeide its somehow fixed but after i restart my pc and re-plug the card it giving me the same error. Why this is happening?
I am using a Nucleo F303RE board. And whenever I try to debug in STM32cubemxIDE. It always shows an error for failed to start GDB error. I have attached the screenshot
I have updated the ST-Link firmware and also checked my device manager.
I have also tried disabling my windows defender.
I have also tried to change the frequency, interface, auto-connect under Debug Configuration.
Would be great if someone could help me out. I am stuck with an important demo at work.
I also tried it on Atollic TrueStudio but still no luck.enter image description here
Thanks
enter image description here
Detailed error on Atollic TrueStudio:
STMicroelectronics ST-LINK GDB server. Version 5.1.0
Copyright (c) 2018, STMicroelectronics. All rights reserved.
Starting server with the following options:
Persistent Mode : Disabled
Logging Level : 1
Listen Port Number : 61234
Status Refresh Delay : 15s
Verbose Mode : Disabled
SWD Debug : Enabled
Target no device found
Error in initializing ST-LINK device.
Reason: No device found on target.
The reason is: No device found on target. This Means the debugger is working but it can't connect to the microcontroller.
The problem may be one of these:
The connection between the debugger and the controller. Check them first.
The serial wire debugger is disabled (I strongly think that this is the problem).
when you create a new project in CubeMX or CubeIDE the serial wire debugger by default is disabled (I expect that you burn the code for only one time :) ). So you MUST erase the flash using stlink utility or such a tool. And enable the serial wire debugger from the CubeMX in category SYS.
I'm trying to run one of the sample projects from Atollic's Getting Started Youtube tutorial. At the debugging stage, the captioned error shows up. I'm at a loss since my board is connected and the video doesn't mention anything about the hardware configurations.
Met the same error, though I'm using a different board (NUCLEO-L452RE). Solved this problem by clicking "ST-Link Update" in "Help" in STM32CubeIDE.
I got error when I goes to install my application in iPhone/iPad.
Application running properly in simulator.
Error message
Couldn't register com.spaceo.pushnotificationtest with the bootstrap server. Error: unknown error code.
This generally means that another instance of this process was already running or is hung in the debugger
Okay your device was struck in debug mode on your previous installation due to some error. You need to restart your device and clean the project in xcode to install application in your device
This generally means that another instance of this process was already running or is hung in the debugger This statement clearly states what was the error so restart your device and try again
I also get this error, restarting my device solves the problem.