CISCO Router Interface Coomands - interface

Question

I am reading book 'CCNA Routing and Switiching Study Guide - Lammle, Todd' wherein there was a command to create an interface (int f0/0).
On CISCO Router command when I am giving a command
Corp(Config)#int f0/0
It is displaying error message as "Invalid interface type and number". Please help me with this command.

Answer 1

If you are working on packet tracer or gns3, go to the arrow on the router to show interface name. Or you can write this command:
corp # show ip interface brief
to find out the interfaces available to you.

Answer 2

Your router doesn't have a module with a port named ' int f0/0 ' , turn off the router in your simulator (Packet tracer, GNS3..) and try to add a module wish have a port with 'int f0/0' ,otherwise, try to understand which port type and number your router has.
Tyr this command in ur CLI: show ip interface brief if it doesn't show u nothing try this 'do show ip interface brief'

Answer 3

when you are in global configuration mode type
hit this coomand:
do show ip int brief
Ip int (put the interface name) and configure it

Answer 4

Well its totally depends on your router's module name...First check the module name by using command show ip interface brief in privilege mode.. if your router have module with f0/0 then only router will enter interface f0/0..