I've purchased a RaspberryPi 3 B+, booted a NOOBS Raspbian and I've been trying to open a ssh connection via an Ethernet connection for the last couple of days. My goal is to be able to access the Pi via ssh while also sharing my Wifi connection to the Pi. My machine is running Ubuntu 18.04.01.
So far I've tried creating a new Profile for the Ethernet connection but without success. The only way the connection can be "successfully" created is by checking the "Link-Local Only" box, which will add "169.254.154.221" to my IP addresses. However, the Pi can't be found on the local network (pinging raspberrypi.local fails and an nmap scan doesn't return any good results).
Also, when I was first trying to connect the Pi, I was able to see it by executing "arp -a" in terminal, but now it is gone.
I've also tried connecting the Pi to my friend's Macbook and the Pi gets a local IP address, but it is still not possible to share the laptop's internet access to the Pi.
Related
I am having trouble connecting to my raspberry pi.
I followed something similar to this tutorial https://howchoo.com/pi/raspberry-pi-gadget-mode
After doing so I found my raspi's ip address to be 224.0.0.251 using arp -a on the terminal. However it seems that I cannot ssh as it gives this error: "Address family not supported by protocol family"
What can I do to ssh my pi?
Because it is a Raspberry Pi 4, it should be able to connect wirelessly over SSH. This is the official documentation for how to do that. https://www.raspberrypi.com/documentation/computers/remote-access.html
Following the instructions at Alpine Wiki - Raspberry Pi - Headless Installation
I was able to get the Pi to boot up and connected to WiFi. I am able to ping it from my laptop, but not able to SSH into it as root. I keep getting the ssh: connect to host <raspberry-pi-ip-addr> port 22: Connection refused error.
Scanning with Nmap shows no ports are open.
How do I get the SSH server to run?
Or at least enable logs and write to SDCARD such that I can look at what is going wrong.
I have installed the 2017-11-29-raspbian-stretch on raspberry 3b, and created a file named ssh in boot directory in SD card, then connected mac with raspberry with an Ethernet cable, I have also turned on Sharing from wifi to Ethernet on mac, but when I wanted connect with raspberry with ssh ssh pi#192.168.2.255 it says "ssh: connect to host 192.168.2.255 port 22: Permission denied".
I have no HDMI cables, what I should do to connect using ssh without visible devices?
It turned out that the Ethernet cable is broken...
Sorry for this question.
I am using D'link rouer DSL-2750U. I have installed raspbian jessie in Rpi 3 and connected it to router. Connected my laptop to router wifi. But when i try to connect putty using the IP address of raspberrypi which i have got from router admin panel it gives connection time out error. Also i have tried to adjust keepalive seconds in putty connection setting and enabled X11 forwarding.
I recommend you to check if ssh is enabled in your device:
sudo raspi-config
then navigate to ssh, hit Enter and select Enable or disable ssh server. Now reboot raspberry and try again.
Please Open you RaspberryPI terminal and run the command "sudo service ssh restart". Try connect again from putty
For everyone who is getting a network error from Putty even all of their network settings are okay, you just follow a single step:
Just go there in Connection and set the time for 10 sec or more.
I'm pretty sure my Username and Password is correct. If I connect raspberry pi with monitor and keyboard, I'll be able to log in.
now, I connect raspberry pi and my desktop in the same network, both using cables. I use PUTTY to connect to raspberry pi, it keeps giving me error says my password is incorrect.
Is possible that PUTTY send a wrong password over the network?
thanks for any helps.