How many devices can be connected to one wire bus and how many temperature sensors(DS18B20) can be connected to Raspberry Pi 3b+?
Related
I have a Raspberry Pi 3 B+ and a Belkin WiFi router. I want to take my existing WiFi signal, and convert it into a modem signal for the router.
Original Wifi -)) ((-Raspberry Pi 3 B+----Modem port on ROUTER-)) New WiFi
How do I do this? I tried Dnsmasq as a WiFi dongle, but I don't think the router likes this.
I'm currently working with Kinect v2. I can do all sort of stuff on PC with it. What I want to do next is, to get the data I want on PC and control the Raspberry Pi with that data (for example, I will move the Pi with motors when I tilt my head to right). I have sorted out the motors and everything but I just don't know how to use that tracking data I have on PC to control the Pi.
I hope the question makes sense, i'm just extremely new to both Pi and Kinect.
Thanks for the help!
The first step is to choose the bus that will connect the
PC to the Raspberry PI.
Your options are:
Serial bus: Pi Serial tutorial,USB Serial to Pi cable
Network Socket (cable/wifi): Socket client/server c++ examples
i2c: i2c windows PC, Configuring i2c on Pi
I believe that the i2c or serial bus will be the easiest to start
with. But in the end all 3 options need to set up the connection, and send and receive bytes / byteArrays.
Since MQ-3 sensor provides analog output, we have got MCP 3008. We tried to make the connections with Raspberry pi 3 using the connections from MQ-2 sensor available online. Nothing works! Need help to interface MQ 3 with Raspberry pi 3 for detecting Alcohol Level
this link is best to interface analog sensor with raspberry pi
https://tutorials-raspberrypi.com/configure-and-read-out-the-raspberry-pi-gas-sensor-mq-x/
use this link but if you want use analog sensor with raspberry pi so you need another ADC module or another chip like PIC , ATMEGA 32
I need help around creating a circuit of more than 100 ultrasonic sensors connected with a single Raspberry Pi(running on Windows 10 IoT core).
When IoT device sends request for Information(broadcast) to these sensors, response from all the sensors should go back to the Raspberry Pi. Then I should be able recognise the response sent by each sensor in my program.
I have studied a bit about I2C pins but not sure how to use it with my very limited electronics knowledge.
I'm trying to connect multiple devices to my Raspberry Pi 3 B+. The components are RFID RC522, RPi LCD display, Load Sensor (strain gauge), and WiFi shield. All those are needed for my project. However GPIO pins overlap almost in every case. I do know that we can parallel the Voltage pin, however I'm super confused how to connect all of it on 1 board. If there's a channel splitter hardware solution or an extended version of RPi or in few words - what's the best way to do it - if possible. Thanks!
I couldn't find the right pictures for weigh sensor with HX711 and wifi shield, but all those need pins.
I think you should look into the MCP3008 ADC (analog to digital converter) as the raspberry pi has no analog gpio pins and it will allow you up to 8 analog sensors to be attached via 4 wires to the Rpi using SPI, For powering things use a breadboard rail to power your sensors from the Rpi but other gpio pins output 3.3v, to get more gpio pins use an MCP23008 chip through I2C. if you're using a Rpi 3 it has built in wifi or you can get a usb wifi antenna.