I am trying to run Google Colab on my Raspberry Pi 3 (Raspberry Pi OS).
If I try to open the page, it remains blank with a hint that Colab might not work on my browser (Chromium).
The link to the FAQ only states that Colab should work on most browsers, e.g. Firefox. So I inistalled Firefox, but it does not work.
I have previously run Colab on my Pi, so I am a bit confused why it is no longer supported. How do you run Colab on Pi?
Related
Since the Widevine support is available for Raspbian I'm able to watch Netflix and Amazon Prime Video on the Raspberry Pi just using the Chromium Browser.
I have, however, a strange behaviour when trying to browse the Amazon Prime Video Webpage when suddenly the whole system just freezes and only hard reboot (unplugging power) will reset the system. This happens every time. I can open the Page, see the Movies and then the whole system just freezes.
Netflix, youtube is working fine.
Has anyone else ever experienced this behaviour?
Raspbian is updated and upgraded.
I can confirm this issue. Opening Prime Video with Chromium causes the page to freeze. I am running Raspberry Pi OS 32 bit with RPi 4 (4 GB RAM). I did install minimal build and then added XFCE desktop.
I want to run my GUI in Raspberry PI but i dont want Raspberry PI's desktop to seen and Nobody can acces the desktop or my codes. Is that possible? if it is how ?
by the way i coded my gui by Python and Pyqt.
I have a question regarding how to uninstall google assistant on the raspberry pi 3. The files are scattered over the place so deleting is not an option. Is there any command to uninstall google assistant on the raspberry pi? I am using the google assistant SDK.
You should be able to run pip uninstall google-assistant-sdk to remove the libraries downloaded. There may be a few config files as well located in ~/.config/google-assistant-* that you can remove.
I have been trying to get pianobar working on my Raspberry Pi. I built version 2013.05.19-dev from Github and it works when I have /etc/libao.conf default_driver=alsa. The problem is that this gives horrible quality audio. I followed the instructions for installing PulseAudio and MPD on dbader's blog. Now when I set default_driver=pulse, pianobar tells me /!\ Cannot open audio device. I have been looking for a solution to this so any tips or help would be great!
i have installed wheezy on my raspberry pi and everything works fine except for the IDLE software where both versions IDLE and IDLE 3 won't open when double clicking them from the desktop or from the start like menu.
i try to open them but nothing happens?!
i don't know what does this have to do with this issue, but i used to connect to raspberry pi by putty and xming11 and at that case the IDLE software didn't open when trying to access it.
however by using tightvnc, this issue was solved!!!